top of page
2026
Robot 1
22" x 22" x 66"
Welded steel, Servo Motors, Electronics, Hardware
This robot's head is set into a randomized loop of motion by three servo motors connected to an Arduino uno
Sand Mandala
20" x 20" x 4"
Cement, Epoxy, Sand, Hardware
Cement tray with an epoxy pour and coating, filled with fine-grain sand. Sphere made with cast epoxy and cement, assembled with steel hardware
Pressure Points / Scissor lift
8.5" x 11" x 6"
Laser-cut MDF, PLA, Wire nails, Hardware
This contraption uses a hand-cranked scissor lift mechanism to lower a piece of fabric under tension onto a bed of wire nails, piercing 280 holes onto the surface of the textile
bottom of page